SLA Castable Resin About
Works with all kinds of SLA 3d printers
Vitaresin SLA resin is a castable resin specially developed for SLA 3D Printers such as Formlabs Form 2, DWS and Peopoly 3d printers.
You can print all kinds of jewellery and achieve very high quality direct casting:
- Ashless direct casting properties
- Can be used for all types of jewellery, including European jewellery or tiny filigree designs.
- Perfect formulation for small wire models up to 0.25 mm
- Excellent casting quality
- Suitable for the standard burnout cycle
- High dimensional stability and low shrinkage
This SLA castable resin is also suitable for dental metal casting. SLA resin is used for crown-bridge, occlusion, partial dentures, laminates and inlay/onlay applications.
Hit
Provides accurate printing with details and can be printed below 10 microns and provides 0.1 mm thickness
Liquid
This resin has a low viscosity. It is easy to clean and provides high lubricity after cleaning
Safe and Odourless
Safe to use. No hazardous solvents or dangerous monomers
100% Ashless, Castable
Specially produced for direct casting. Evaporates with heat without leaving ash
Easy to Cast
Easy casting with investments such as Sherafine, Polyvest, Siladent, Bego, Nanovest or others
Best Filigree for SLA
Perfect formulation for models with small strands up to 0.25mm
Our Apps
Work Flow Chart
Özellikler
| Material Feature | Value | Standard |
|---|
Vitaresin SLA After Treatment
1- Washing
- After printing is complete, wash the part attached to the build plate with ethyl alcohol (>90%) or isopropyl alcohol (>90%) for 5 minutes.
- When washing, make sure that the alcohol completely covers the part.
- Use a brush to remove uncured resin if necessary.
- Do not over wash, it may cause distortion in the dimensions of the part.
2- Drying
- Use an air compressor to dry the washed part.
- Make sure the part is dry and the uncured resin is completely removed.
- If there is still uncured resin left on the part, wash with fresh alcohol and dry again.
3- Part Disassembly
- Remove the printed part from the build plate using a scraping tool, being very careful not to damage your hand and the model.
- Store the Vitaresin SLA bottle in a dark and moisture-free place at room temperature (20-24 °C).
About Primer Resin Strong Adhesion
Vitaresin is a resin with very strong adhesion properties and designed to be used for all LCD, DLP and SLA technology printers with adhesion problems.